Air and nitrogen circulation heater - 1 Non-insulated DN80 body - 2 kW - 400 V 1P

Product N° : 10901.03
Vulcanic air and nitrogen circulation heater View1
search
  • Vulcanic air and nitrogen circulation heater View1
  • Air and nitrogen circulation heater Vulcanic DrawLN460

Circulating gas heater for heating air or nitrogen to a maximum temperature of 150 °C and a maximum operating pressure of 14.2 bar.g. Consisting of 1 non-insulated DN80 316L stainless steel body with 2" gas inlet/outlet tappings.

The heater is equipped with a body safety thermostat with automatic reset, adjustable range from 0 to 300 °C and 1 screw-in immersion heater M77 x 200 with a unitary power of 2 kW/400 V 1P.

Can be made , Under 21 days

Total heater power (kW) :
2
Power tolerance :
+5/-10%
Heater supply voltage :
400 V 1P
State of the fluid to be heated :
Gas
Type of fluid to be heated :
Air or nitrogen
Number of heating units :
1
Heater insulation :
Not insulated
Specific load (W/cm2)
1.7
Min/max input temperature (°C) :
5 / 110
Maximum output temperature (°C) :
150
Maximum operating pressure (bar.g) :
14.2
Minimum flow at rated power :
120 kg/h
Body diameter DN :
80
LN pole of the heater (mm) :
460
Body material :
316L Stainless steel
Internal body treatment :
Sans
External body treatment :
Sans
Input/output tapping :
2'' gas tap
Support stands material :
Protected steel
Insulation material :
Sans
Body safety device :
Adjustable thermostat from 0 to 300 °C with automatic reset
Immersion heater part number :
2077.13
Unit power of the immersion heater (kW) :
2
Material of the heating pins :
316L Stainless steel
Joining of pins to the flange :
Brazed
Cap thread diameter :
M77 x 200
Cap thread material :
Acier
Connector protection box :
H1 Terminal box - IP55 - Polyamide
Cable gland :
1 ISO 25 polyamide cable gland Ø 9 to 18 mm
Category of the PED 2014/68/EU :
Equipment covered by article 4§3
Min. permissible temperature / TS min. (°C) :
5
Max. permissible temperature / TS max. (°C) :
300
Max. permissible pressure / PS max. (bar.g) :
15
Heater mounting position :
Horizontal
Construction code :
Standard Vulcanic
  • User manual

  • Datasheet