Screw plug immersion heater 1''1/4 gas cyl. - 750 W / 230 V 1P - 5W/cm2 - Without junction box
Product N° : 2041.01
Screw plug immersion heater 750 W / 230 V 1P recommended for heating softened or recycled water up to 100 °C. It consists of 2 shielded stainless steel 321 heating elements soldered on a 1''1/4 gas cyl. threaded fixing plug in protected steel. The heating elements have a plunge length of 205 mm and are loaded at 5 W/cm2. The immersion heater is equipped with a M45 x 200 threaded interface, on the connector side, for the mounting of a junction box (supplied as an option, see accessories). Maximum allowable pressure 15 bar.g. It is supplied with 1 fibre seal.
- Plug thread standard :
- Cylindrical gas BSPP
- Screw plug diameter :
- 1''1/4
- Immersion heater power (W) :
- 750
- Power tolerance :
- +5/-10%
- Supply voltage :
- 230 V 1P
- Recommended fluid heating :
- Softened or recycled water
- Maximum allowable temperature / TS max (°C) :
- 110
- Maximum operating temperature (°C) :
- 100
- Maximum allowable pressure / max PS (bar) :
- 15
- Specific load (W/cm2) :
- 5
- Immersion length A (mm) :
- 205
- Number of heating elements :
- 2
- Shape of resistance :
- Simple pins
- Resistor diameter :
- 6.8
- Heating elements material :
- 321 Stainless steel
- Resistance treatment :
- No treatment
- Plug material :
- Acier
- Connection of the resistors to the plug :
- Brazed
- Bounding of resistors :
- Hexagonal terminals with hole
- Resistor coupling :
- Uncoupled
- Non-heating length Nh (mm) :
- 30
- Connector offset B (mm) :
- Without
- Max. pin bundle diameter ØF (mm) :
- 22
- Dimension on/flats of plug H (mm) :
- 60
- Sealing of resistors :
- WP+ - Resin (Reinforced sealing, 160 °C max. at terminals)
- Control or safety device no. 1 :
- Without
- Connector protection box :
- Without
- Junction box mounting interface :
- Threaded interface M45 x 201
- Weight (kg) :
- 0.7
- Accessories included:
- 1 Fibre seal
-
User manual
Spare parts and accessories
